2/12/2024 0 Comments Peter wright anvil weight codeIf this happens, stop welding and strat running your passes from the opposite direction. Magnetic (or "arc") Blow may occur as you will be running a lot of passes in the same direction. I wire wheel and grind each pass and inspect the toe where the weld burns into the base metal (anvil) These stringer beads build up that edge or bottom of the chipped corner and give you a shelf to build more weld off of. run two stringer beads on the side of the anvil, one next to the other fused together, on the side of the anvil so they build up that bottom edge of roll the anvil on it's side so what would be the bottom edge of the chipped corner is in the flat position. grind the chipped edge so it is completely down to sound steel and blends with radius's. If you have a cracked or chipped corner or edge on the anvil, here is how I made the repair: I backstep about 1/2" on the stitches when starting the tie-in welds, and carry them onto the next stitch by 1/4- 1/2". I laid the weld in small stitches on the longer areas, rather than running continuous beads. I preheat the area to be welded to about 400 degrees F as you noted, using a roesebud. Preheating the anvil is claimed by MG Messer as normally not required with MG 710 unless you know the areas being repaired are high carbon steel ( carbon > 0.40 %). Grind areas so therre are no sharp "vees" or sharp corners, going for "easy transitions". I personally just used a good light, magnifying glass and a scriber to probe with. You can do a dye pentrant test if you are comfortable and familiar with it to verfiy you ground past the base of any cracking. To repair the anvil, you will need to grind out the areas which have been chipped or cracked. As welded hardness will be 55-60 Rockwell C. ![]() MG 710 weld deposits are non-machineable and must be ground to shape the repaired areas of the anvil. A 5 lb container of MG 710 stood me 100 bucks over 10 years ago. It can be used for repair/buildup welding on most tool steels. I did some research into the matter, and came up with a specialty electrode made by MG Messer. I rresurfaced and repaired a few anvils using stick welding.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |